Install Memgraph from RPM package
This article briefly outlines the basic steps necessary to install and run Memgraph from a RPM package.
Newer versions of Memgraph might not be backward compatible with older versions and you might not be able to load storage snapshots between different versions. In that case, please contact the Memgraph team and we'll help with the migration as much as possible.
Before you proceed with the installation guide make sure that you have:
- The latest Memgraph RPM Package which can be downloaded from the Memgraph download hub.
Memgraph packages are available for:
- CentOS 7
- CentOS 9
- Fedora 36
- RedHat 7
- RedHat 9
You can also use direct download links to get the latest Memgraph packages.
After downloading the Memgraph RPM package, you can install it by issuing the following command:
sudo yum --nogpgcheck localinstall /path-to/memgraph-<version>.rpm
NOTE: Please take care of the SELinux config. The easiest way of
running Memgraph is to disable SELinux by executing
setenforce 0. If that's
not an option, please configure system properly.
After successful installation, Memgraph can be started as a service using the following command:
systemctl start memgraph
To verify that Memgraph is running, run the following command:
journalctl --unit memgraph
If successful, you should receive an output similar to the following:
You are running Memgraph vX.X.X
If you want the Memgraph service to start automatically on each startup, run the following command:
systemctl enable memgraph
If you want to start Memgraph with different configuration settings, check out the Configuration section. At this point, Memgraph is ready for you to submit queries.
To shut down the Memgraph server, issue the following command:
systemctl stop memgraph
The Memgraph configuration is available in
/etc/memgraph/memgraph.conf. If the
configuration file is altered, Memgraph needs to be restarted. To learn about
all the configuration options, check out the Reference
Where to next?
To learn how to query the database, take a look at the
querying guide or Memgraph
Playground for interactive tutorials.
Visit the Drivers overview page if you need to connect to the database programmatically.
If you run into problems during the installation process, check out our installation troubleshooting guide to see if we have already covered the topic. For more information on the installation process and for additional questions, visit the Help Center page.