This article briefly outlines the basic steps necessary to install and run Memgraph on Linux with Docker.
Memgraph Platform contains:
- MemgraphDB - the database that holds your data
- Memgraph Lab - visual user interface for running queries and visualizing graph data
- mgconsole - command-line interface for running queries
- MAGE - graph algorithms and modules library
Newer versions of Memgraph are currently not backward compatible with older versions. That is why you won't be able to load storage snapshots between different versions.
- Docker Desktop - Memgraph Platform can be installed only with Docker.
Instructions on how to install Docker can be found on the official Docker website.
Memgraph's Docker image was built with Docker version
1.12 and should be
compatible with all newer versions.
Install and start Memgraph Platform
Open a terminal and use the following command:
docker run -it -p 7687:7687 -p 7444:7444 -p 3000:3000 -v mg_lib:/var/lib/memgraph memgraph/memgraph-platform
If successful, you should see a message similar to the following:
Connected to 'memgraph://127.0.0.1:7687'
Type :help for shell usage
Quit the shell by typing Ctrl-D(eof) or :quit
Command-line tool mgconsole is open in the terminal, and the visual user
interface Memgraph Lab is available at
User either mgconsole, Memgraph Lab or various drivers to connect to MemgraphDB.
Stop Memgraph Platform
To stop a Memgraph database instance, run the following command:
docker stop CONTAINER_NAME
You can find the name of the container (
CONTAINER_NAME) by running the following command in a new terminal:
Configuration file and logs
If you need to access the Memgraph configuration file or logs, you will need to specify the following volumes when starting Memgraph:
docker run -it -p 7687:7687 -p 7444:7444 -p 3000:3000 -e MEMGRAPH="--bolt-port=7687" \
-v mg_lib:/var/lib/memgraph \
-v mg_log:/var/log/memgraph \
-v mg_etc:/etc/memgraph \
The configuration file is located in the
mg_etc volume. The exact location of
the file depends on your specific setup, but usually it is
The logs will be saved to the
mg_log volume, and the directories can usually be found in
When using Docker, you can also specify the configuration options in the
docker run -it -p 7687:7687 -p 7444:7444 -p 3000:3000 -e MEMGRAPH="--bolt-port=7687" memgraph/memgraph-platform
When working with Memgraph Platform, you should pass configuration flags inside of environmental variables.
For example, you can start the MemgraphDB image with
docker run memgraph
--bolt-port=7687, but you should start Memgraph Platform with
docker run -e MEMGRAPH="--bolt-port=7687"
To learn about all the configuration options, check out the Reference guide.
Where to next?
If you need more information on working with Docker, check out our guide on how
to work with Docker.
To learn how to query the database, take a look at the querying guide or Memgraph Playground for interactive tutorials.
Visit the Drivers overview page if you need to connect to the database programmatically.
If you run into problems during the installation process, check out our installation troubleshooting guide to see if we have already covered the topic. For more information on the installation process and for additional questions, visit the Help Center page.